HOME PAGE                ABOUT US          PRIVACY        CONTACT US


Simple, Fast, Free Estimates!
No Obligation, Find Out How Much You Can Save !


    


...........................................................................




 

 

Thank you for visiting our remodeling contractors website.

   Our remodeling contractors estimate general contractor website is designed exclusively for the homeowner and/or renter to get their job done efficiently and in a timely manner.

  We are dedicated to giving you an easy estimate request form for your remodeling project and following up with prompt and courteous service. We believe that between the customers request and our contractors skill your home improvement project will be a wonderful and delightful experience.

  Fill out the easy form and give us an idea of the project you wish to complete and you will receive an estimate from a qualified and licensed contractor. The benefit of a licensed contractor gives you assurance that your project is in capable hands and the job will be done right from start to finish.



Bathroom Trivia

A bathroom is a room that may have different functions depending on the cultural context it is used in.

In its literal sense it means 'a room with a bath', but as bathtubs have partly made way for showers and steam showers, the more general sense of 'a room where one bathes' makes more sense. There can be just a shower or just a bathtub or both, sometimes combined and sometimes separate (in which case the bathtub may have a second shower). Usually, it also contains a handbasin or sink and often also a toilet. In the USA, 'bathroom' commonly means 'a room containing a toilet' (in other countries this is usually called 'toilet' or alternatively 'water closet' (or 'WC'), or 'lavatory'). For this interpretation of the word see bathroom (American). If a bathroom facility is attached to a bedroom it is often known as an en-suite or if it's attached to a master bedroom it's known as a master bathroom.

A half (1/2) bath contains a toilet and a handbasin (lavatory). A 3/4 bath contains a toilet, a handbasin (lavatory) and a shower. A full bath contains a toilet, a handbasin (lavatory) and a bathtub.

  For information and articles about contractor laws and licensing we have included a link for your convenience. To find out more, simply click on the corresponding state you wish to obtain information from. - Home improvement contractor info

Additional information and resources:

Read Home Decorating Articles - We have included a great resource link for you to get ideas about designing to compliment any home improvement project. The link will open in a new window so you may keep our estimate form open for easy access.

Find Decorating Pictures - Finally...a source for interior decorating and gardening pictures! A giant selection of home and garden, and interior decorating from a great website that will give you many ideas about updating your home with an array of well thought ideas. Link opens in new window so you may return for an estimate.




Design considerations

The design of a bathroom must account for the use of both hot and cold water, in significant quantities, for cleaning the human body. Disposal of the water usually leads to a sewer or septic tank. Water may be splashed on the walls and floor and hot humid air may cause condensation on cold surfaces. From a decorating point of view the bathroom presents a challenge. Ceiling, wall and floor materials and coverings should be impervious to water and readily and easily cleaned. The use of ceramic or glass, as well as smooth plastic materials, is common in bathrooms for their ease of cleaning. However, such surfaces are often cold to the touch and so water-resistant bath mats or even bathroom carpets may be used on the floor to make the room more comfortable. Alternatively, the floor may be heated, possibly by startegically placing heater conduits close to the surface.

Electrical appliances, such as lights, heaters and heated towel rails generally need to be installed as fixtures, with permanent connections rather than plugs and sockets. This minimises the risk of electric shock. Ground-fault circuit interruptor electrical sockets can reduce the risk of electric shock, and are required for bathroom socket installation by electrical and building codes in the United States and Canada. In some countries, such as the UK, only special sockets suitable for electric shavers are permitted in bathrooms, and are labelled as such.

Bathrooms can also be a source of decorative inspiration. One can easily decorate the bathroom by choosing shower curtains or cubicles to match a theme.




Home Improvement Information

Single Pane Window Glass Repair in an Aluminum Frame


Let's suppose you still have those old aluminum single pane windows in your house,and one of the neighbor kids throws a ball through it. ( Your kid would never do that!) Depending on where you live in the country, you can pay anywhere from $75 to $150 to get it repaired. Well, if you're willing to spend an hour or two, you can get the window fixed for around $20 or $30. I'm not going to try and explain how to cut your own glass. I am going to explain how to get the old glass out, measure for the new glass, and install the replacement glass. So, let's use this article to explain the most common type of aluminum frame window.

If you have a sliding window, one of the panels will be stationary, and the other will slide back and forth. If the slider is the one broken, you simply lift up and swing the bottom out. If the bottom won't come out, check for rollers on top. Sometimes the top rollers are adjusted up so the slider can't be removed. Just loosen the screw holding the roller in place and lift up with some force. That should push the rollers down, allowing you to remove the panel. Lay the panel on a table and measure the width and height of the glass only. Take this measurement and add 1/2" to both the width and height. This is the size of the new glass that you need to order. Measure the thickness of the old glass. It will either be 1/8" or a little less than that. The thin glass is called single strength and is actually about 3/32". The 1/8" glass is called double strength glass. Be sure to order the right one. If you order double strength glass because you figure it's stronger than the old single strength piece, you are going to have a devil of a time putting the frame back together. That tiny 1/32" difference can be a real pain in the neck. Trust me, you want to replace single strength with single strength.

Now, it's time to take the frame apart and remove all of the old glass. Make sure to put on a heavy pair of gloves to avoid getting cut. You will find a screw in each corner of your frame. You want to remove two of these screws in opposite corners. So, if you remove the bottom left screw, you need to also remove the top right one. Now, take a rubber mallet, slide one of the corners off the table that has the screw removed, and tap the frame to separate it from the glass. Set that half of the frame aside, then do the same thing to the other half. Now you should have two halves of the frame, a piece of rubber, and lots of glass. Throw away all the glass, then clean out the rubber, making certain to get every piece of glass out of there.

When You get the replacement glass home, lay it on the table with one long and one short side hanging over the edge. Put the rubber on those two overhanging edges. Put one half of the frame (it doesn't matter which half) against the glass and tap the corner on first. Then tap the long edge onto the rubber until it seats. Then do the short edge. Now, put the other two edges over the table and do the same procedure. Finally, install the screws in the corners. Put the panel back in and you're done.

If the broken pane is the stationary portion, there is a little extra work to get the panel out. You need to take out the slider first, then remove the two screws holding the center bar in place. Tap the center bar away from the panel until it is off the side of the panel. Set it aside. Then tap the frame edge to pull it out of the channel attached to the wall. Once it's away from the side channel, you can lift it up and out like you did with the slider. You remove and install the glass in the frame just like you did with the slider, put the frame back in the opening, tap it into the side channel, install the center bar and screws, and install the sliding panel. That's it! You're done. If your window doesn't fit this description, fear not! I will be spending the next several weeks trying to cover every conceivable window configuration. So, i will chat with you all next week.

John Rocco has been installing replacement windows since 1978. To learn more, visit How To Install Windows


MORE RESOURCES:
You told us your 2009 resolutions, from replacing electrical outlets to overhauling landscaping. We help you get the job done

One look at the dilapidated 1926 foursquare—smack in the middle of beach-condo country—sealed the deal for this couple.

A from-scratch kitchen with every convenience and finely crafted woodwork is a natural fit for a Craftsman-style home

Fancy fireplace fronts. The Victorians used them to improve the look of their hearths in the off-season, but you can put them to work today to upgrade your interior rooms year-round

Ever wonder what's inside those beautiful city rowhouses? Here's a glimpse of a century-old Renaissance Revival—TOH TV's new project—filled with well-preserved details

Buried by a blizzard? Follow our tips for digging out

Here at This Old House, we're big fans of DIY builders. But little did we know that the tools of the trade—band saws, wood rasps, belt sanders, Dremels—could be used to build dessert

We've had a hive of bees move into a very old olive tree in our front yard. I really don't want to do them any harm, as I understand bees are suffering from hive collapse. But, I do have concerns regarding bite allergies. Is there any way to get the bees to leave voluntarily?

home   |   site map
  ©  Copyright 2003-2006. All rights reserved.    Powered by   HostGator.com    Remodeling Contractors Estimate Form    Do it yourself