HOME PAGE                ABOUT US          PRIVACY        CONTACT US


Simple, Fast, Free Estimates!
No Obligation, Find Out How Much You Can Save !


    


...........................................................................




 

 

Thank you for visiting our remodeling contractors website.

   Our remodeling contractors estimate general contractor website is designed exclusively for the homeowner and/or renter to get their job done efficiently and in a timely manner.

  We are dedicated to giving you an easy estimate request form for your remodeling project and following up with prompt and courteous service. We believe that between the customers request and our contractors skill your home improvement project will be a wonderful and delightful experience.

  Fill out the easy form and give us an idea of the project you wish to complete and you will receive an estimate from a qualified and licensed contractor. The benefit of a licensed contractor gives you assurance that your project is in capable hands and the job will be done right from start to finish.



Bathroom Trivia

A bathroom is a room that may have different functions depending on the cultural context it is used in.

In its literal sense it means 'a room with a bath', but as bathtubs have partly made way for showers and steam showers, the more general sense of 'a room where one bathes' makes more sense. There can be just a shower or just a bathtub or both, sometimes combined and sometimes separate (in which case the bathtub may have a second shower). Usually, it also contains a handbasin or sink and often also a toilet. In the USA, 'bathroom' commonly means 'a room containing a toilet' (in other countries this is usually called 'toilet' or alternatively 'water closet' (or 'WC'), or 'lavatory'). For this interpretation of the word see bathroom (American). If a bathroom facility is attached to a bedroom it is often known as an en-suite or if it's attached to a master bedroom it's known as a master bathroom.

A half (1/2) bath contains a toilet and a handbasin (lavatory). A 3/4 bath contains a toilet, a handbasin (lavatory) and a shower. A full bath contains a toilet, a handbasin (lavatory) and a bathtub.

  For information and articles about contractor laws and licensing we have included a link for your convenience. To find out more, simply click on the corresponding state you wish to obtain information from. - Home improvement contractor info

Additional information and resources:

Read Home Decorating Articles - We have included a great resource link for you to get ideas about designing to compliment any home improvement project. The link will open in a new window so you may keep our estimate form open for easy access.

Find Decorating Pictures - Finally...a source for interior decorating and gardening pictures! A giant selection of home and garden, and interior decorating from a great website that will give you many ideas about updating your home with an array of well thought ideas. Link opens in new window so you may return for an estimate.




Design considerations

The design of a bathroom must account for the use of both hot and cold water, in significant quantities, for cleaning the human body. Disposal of the water usually leads to a sewer or septic tank. Water may be splashed on the walls and floor and hot humid air may cause condensation on cold surfaces. From a decorating point of view the bathroom presents a challenge. Ceiling, wall and floor materials and coverings should be impervious to water and readily and easily cleaned. The use of ceramic or glass, as well as smooth plastic materials, is common in bathrooms for their ease of cleaning. However, such surfaces are often cold to the touch and so water-resistant bath mats or even bathroom carpets may be used on the floor to make the room more comfortable. Alternatively, the floor may be heated, possibly by startegically placing heater conduits close to the surface.

Electrical appliances, such as lights, heaters and heated towel rails generally need to be installed as fixtures, with permanent connections rather than plugs and sockets. This minimises the risk of electric shock. Ground-fault circuit interruptor electrical sockets can reduce the risk of electric shock, and are required for bathroom socket installation by electrical and building codes in the United States and Canada. In some countries, such as the UK, only special sockets suitable for electric shavers are permitted in bathrooms, and are labelled as such.

Bathrooms can also be a source of decorative inspiration. One can easily decorate the bathroom by choosing shower curtains or cubicles to match a theme.




Home Improvement Information

Sliding Glass Door Replacement


This article is going to be about replacing an old sliding glass door with a modern Vinyl frame sliding glass door. If you currently have french doors and you want to replace them with sliding doors, or vise versa, future articles will cover that topic.

The first thing we have to do is measure for the replacement door. You want to measure across the bottom, center, and top of the existing door frame to find the narrowest dimension. Start outside and measure at the point where the old door frame stops and the exterior material starts. That material can be stucco, siding, or brick. Measure across in the 3 places: bottom, center, and top. Record the smallest dimension. Then go inside and do the same thing. You want to measure where the frame ends and the drywall, plaster, or sheetrock begins. Take all six measurements, find the narrowest one, and deduct 3/4". That is the width of the new door. Now, when you measure the height, you can do it just on the outside. Measure the left, center, and right side from the ground where the bottom track sits, up to the top where the old frame ends and the exterior material begins. Take the narrowest dimension and deduct 1/2". That is your height of the new door. Then, determine which side the sliding panel should be on. The fixed panel is designated by the letter "O", and the slider is an "X". In most areas of the country, you call it out by looking at the door from outside and reading left to right. So, if you were outside looking at your door, and you want the sliding panel to close to the right wall, you would ask for an "OX". However, because i have recently discovered that not all parts of the country do it this way, my suggestion is to ask the dealer how they read the opening before placing your order.

Next, you have to decide whether you want a retrofit frame or a replacement frame. If the old frame is flush with the exterior material, such as in the case of stucco, then you want to get the retrofit frame, which comes with the outside fin. That will eliminate the need to trim the outside. If you have brick or siding surrounding the opening, then you need to get a replacement frame and trim the outside yourself. You can use wood, vinyl, or other composite materials available in most major hardware store chains. You also need to measure the depth of the old frame. The majority of vinyl replacement doors have a frame depth of 4 3/4". Most door openings, when framed, have a depth of 5 1/2" to the innermost surface of the wall, whether it's drywall, plaster, or whatever else. Therefore, when you install the new door, you will need to add some sort of trim product to build the inside of the door frame so it is flush with the wall surface. We sell vinyl extrusions specifically for this purpose. It's a two piece system that allows you to bring the frame flush with the wall, then apply the molding to the wall and door frame to finish it. Pictures and descriptions of the products are available by going to http://www.how-to-install-windows.com and clicking on "Product Catalog".

You want to be sure and order all of the materials you will need to do the job at the same time that you order the replacement door. That way, when the new door comes in 2 to 4 weeks later, you will have everything ready to do the job. In addition to any trim needed, you are also going to need caulk, a roll of R-13 Insulation, liquid nails for the track, 4" deck screws, shims, dust masks, and safety glasses. Once the new door arrives, it will be time to take out the old door. That will be our topic in next week's article.

John Rocco has been installing replacement windows since 1978. To learn more, visit How To Install Windows


MORE RESOURCES:
These smart upgrades and fixes won't cost you a lot of money, but they could help you clinch a deal if you're trying to sell

You told us your 2009 resolutions, from replacing electrical outlets to overhauling landscaping. We help you get the job done

One look at the dilapidated 1926 foursquare—smack in the middle of beach-condo country—sealed the deal for this couple.

A from-scratch kitchen with every convenience and finely crafted woodwork is a natural fit for a Craftsman-style home

Fancy fireplace fronts. The Victorians used them to improve the look of their hearths in the off-season, but you can put them to work today to upgrade your interior rooms year-round

Ever wonder what's inside those beautiful city rowhouses? Here's a glimpse of a century-old Renaissance Revival—TOH TV's new project—filled with well-preserved details

Buried by a blizzard? Follow our tips for digging out

The seller of my new home had all the rooms freshly painted. Now we are noticing cracks where trim meets wall and wall meets ceiling. These cracks were not present when we closed. Why did this happen and how do we fix?

home   |   site map
  ©  Copyright 2003-2006. All rights reserved.    Powered by   HostGator.com    Remodeling Contractors Estimate Form    Do it yourself