HOME PAGE                ABOUT US          PRIVACY        CONTACT US


Simple, Fast, Free Estimates!
No Obligation, Find Out How Much You Can Save !


    


...........................................................................




 

 

Thank you for visiting our remodeling contractors website.

   Our remodeling contractors estimate general contractor website is designed exclusively for the homeowner and/or renter to get their job done efficiently and in a timely manner.

  We are dedicated to giving you an easy estimate request form for your remodeling project and following up with prompt and courteous service. We believe that between the customers request and our contractors skill your home improvement project will be a wonderful and delightful experience.

  Fill out the easy form and give us an idea of the project you wish to complete and you will receive an estimate from a qualified and licensed contractor. The benefit of a licensed contractor gives you assurance that your project is in capable hands and the job will be done right from start to finish.



Bathroom Trivia

A bathroom is a room that may have different functions depending on the cultural context it is used in.

In its literal sense it means 'a room with a bath', but as bathtubs have partly made way for showers and steam showers, the more general sense of 'a room where one bathes' makes more sense. There can be just a shower or just a bathtub or both, sometimes combined and sometimes separate (in which case the bathtub may have a second shower). Usually, it also contains a handbasin or sink and often also a toilet. In the USA, 'bathroom' commonly means 'a room containing a toilet' (in other countries this is usually called 'toilet' or alternatively 'water closet' (or 'WC'), or 'lavatory'). For this interpretation of the word see bathroom (American). If a bathroom facility is attached to a bedroom it is often known as an en-suite or if it's attached to a master bedroom it's known as a master bathroom.

A half (1/2) bath contains a toilet and a handbasin (lavatory). A 3/4 bath contains a toilet, a handbasin (lavatory) and a shower. A full bath contains a toilet, a handbasin (lavatory) and a bathtub.

  For information and articles about contractor laws and licensing we have included a link for your convenience. To find out more, simply click on the corresponding state you wish to obtain information from. - Home improvement contractor info

Additional information and resources:

Read Home Decorating Articles - We have included a great resource link for you to get ideas about designing to compliment any home improvement project. The link will open in a new window so you may keep our estimate form open for easy access.

Find Decorating Pictures - Finally...a source for interior decorating and gardening pictures! A giant selection of home and garden, and interior decorating from a great website that will give you many ideas about updating your home with an array of well thought ideas. Link opens in new window so you may return for an estimate.




Design considerations

The design of a bathroom must account for the use of both hot and cold water, in significant quantities, for cleaning the human body. Disposal of the water usually leads to a sewer or septic tank. Water may be splashed on the walls and floor and hot humid air may cause condensation on cold surfaces. From a decorating point of view the bathroom presents a challenge. Ceiling, wall and floor materials and coverings should be impervious to water and readily and easily cleaned. The use of ceramic or glass, as well as smooth plastic materials, is common in bathrooms for their ease of cleaning. However, such surfaces are often cold to the touch and so water-resistant bath mats or even bathroom carpets may be used on the floor to make the room more comfortable. Alternatively, the floor may be heated, possibly by startegically placing heater conduits close to the surface.

Electrical appliances, such as lights, heaters and heated towel rails generally need to be installed as fixtures, with permanent connections rather than plugs and sockets. This minimises the risk of electric shock. Ground-fault circuit interruptor electrical sockets can reduce the risk of electric shock, and are required for bathroom socket installation by electrical and building codes in the United States and Canada. In some countries, such as the UK, only special sockets suitable for electric shavers are permitted in bathrooms, and are labelled as such.

Bathrooms can also be a source of decorative inspiration. One can easily decorate the bathroom by choosing shower curtains or cubicles to match a theme.




Home Improvement Information

How To Replace The Rollers On Your Patio Door


Have you noticed your patio door is getting harder and harder to open? Maybe it's time to change the rollers on the door. They generally last from ten to fifteen years but they do wear out and its a job that a do-it-yourselfer can accomplish with a little advice and some strong arms to get the door out!

Sliding patio doors are usually aluminum but there are many wooden and vinyl models on the market. All of them use ball bearing rollers to slide easily back and forth. The aluminum and some vinyl doors have a door bottom that is held in place by 2 screws on either side of the door near the bottom. Beneath the screw is usually an open hole in which there is an adjusting screw to raise the roller up and down. The wooden doors often have pairs of rollers due to their extra weight. The adjusting screws are accesible through plastic caps covering holes in the front of the door bottom.

I mention the adjusting screws because you need to check them before deciding to pull the door out and replace the rollers. Slide a big flat blade screwdriver underneath the door on one side and lift slightly to remove the weight from the roller. Use another screwdriver to turn the adjustment screw. See if that makes the door slide better.

Sometimes thats all thats necessary but if the adjusting screws wont turn or are totally missing, you will have to lift the door out of its track and remove the large screws holding the door bottom on and pull the door bottom off. Get help to lift the door out. Two people are needed to safely handle even the smaller patio doors. The door bottom may not pull off easily especially if the door is old. Check for any metal tabs that may be holding it on and gently work the bottom off.

Some old aluminum and vinyl patio doors have rollers that use one screw both to mount the roller and to adjust it. These types of rollers can often be changed without removing the bottom of the door. Look carefully at the bottom of the door in case there is room to pull the roller assembly out.

Wooden patio door rollers are somewhat easier to change, although the door itself is much heavier. The rollers are often screwed in to the wood door bottom. Remove the screws, and out come the roller.

Some Vinyl patio doors are glued together. They were never intended to come apart. You may not be able to remove the rollers if you see no visible screws holding the frame together. Also vinyl doors are often brittle with age and crack easily as you try to pry off the door bottom. Take extra care if you have a vinyl patio door.

Once you have the bottom off the patio door it should be easy to see how the rollers are held in. Usually, removing one screw or bending a metal tab is all thats necessary. Remove the rollers and take them with you to your local glass shop to get the proper replacements.

To reassemble everything start by adjusting the new rollers so they are up as high as they can go. You dont want them getting in the way when you reinstall the door on its track. Make sure you cover the roller retaining screws with cork or rubber if they come near the bare glass in the door bottom. If the metal screws touch the glass, it will crack.

Replace the door bottom, reinstall the screws that secure it and lift the door back in to place. Follow the instructions gave earlier for adjusting the rollers. You should now be able to see the door move up and down when you turn the adjusting screws. You will also be able to align the door with the frame using the screws. Your patio door lock may need to be adjusted to compensate for the new door height.

Try the door and you should be amazed at how easy it is to close. It should only require a couple of pounds of force to open and close. No more fighting with a heavy door and you did it all yourself!

About The Author

Adrian Dunevein runs a self help website for people who want to do their own window and door screen repair. The website is a complete resource for anyone needing to repair or replace any type of screen.

adrian@all-about-screen-doors.com


MORE RESOURCES:
A design pro updated her galley kitchen by annexing space, widening entries, and making creative use of open shelves

This Old House general contractor Tom Silva shows the proper and safe way to remove an old finish from a hardwood floor

When used safely, a space heater lets you keep a small area toasty without having to make the rest of the house feel like a sauna. Here are the ins and outs of the latest models

See how these homeowners transformed a stuck-in-time 1950s Cape Cod into a comfortable home for today

Save the earth and your budget with these noteworthy eco-friendly products

You asked for it: medicine cabinets with built-in extras that resolve everyday issues

This Old House plumbing and heating expert Richard Trethewey shows the proper way to replace an old kitchen faucet

I own a 1870's home with a fieldstone foundation, which is in great shape except for a few cracks in one area. How do I repair those to prevent leaking after rainfall?

home   |   site map
  ©  Copyright 2003-2006. All rights reserved.    Powered by   HostGator.com    Remodeling Contractors Estimate Form    Do it yourself